KitchenAid 5KSM7990X Manual De Uso Y Cuidado página 9

PRODUCT ASSEMBLY
6
Test the beater to bowl clearance: Plug
the Stand Mixer into an earthed outlet.
Turn Stand Mixer ON and test each
speed, making sure the beater does not
touch the bowl during operation. If the
beater is too far away from the bottom or
is hitting the Bowl, proceed to next step
to make adjustments.
IMPORTANT: When properly adjusted, the Stainless Steel Flat Beater will not strike on the
bottom or sides of the bowl. If the flat beater or the wire whip is so close that it strikes the
bottom of the bowl, coating may wear off the beater or wires on the whip may wear.
USING THE BOWL GUARD* AND POURING CHUTE*
1
To attach the Bowl Guard*: Make sure
that the guard is returned to the down
position before beginning to use the Stand
Mixer. The Stand Mixer will not run if the
Bowl Guard is not in the proper position.
*Available with select models only and available as an accessory purchase.
Auto-Reset Motor Protection: If the Stand Mixer stops due to overload,slide the Speed
Control Lever to "OFF (0)" and unplug the Stand Mixer. After a few minutes, the Stand Mixer
will automatically reset. Plug the Stand Mixer back in and slide the Speed Control Lever to the
desired speed and continue mixing. If the Stand Mixer does not restart, unplug the Stand Mixer
for a longer period of time to allow it to cool, then plug back in and restart the Stand Mixer.
Stop Switch: If you need to stop the Stand Mixer immediately during use, press the Stop
Switch. To resume operation, reset the Speed Control Lever to "OFF (0)", and pull out the Stop
Switch. Then, your Stand Mixer is ready to be used normally again.
W11457004A.indb 9 W11457004A.indb 9
7
Lower Bowl Lower Bowl
Raise Bowl Raise Bowl
(OPTIONAL) To adjust Beater to
Bowl clearance: Lower the Bowl to the
down position. Turn the screw slightly
counterclockwise (left) to raise the Beater,
or clockwise (right) to lower it. Adjust the
beater so that it just clears the surface of
the Bowl. Check again the clearance of
the Beater to the Bowl.
2
Place the Pouring Chute*: Attach the
pouring shield to the front of Bowl
Guard. It provides a convenient way to
add ingredients to the Stand Mixer Bowl.
9
03-09-2020 11:42:31 03-09-2020 11:42:31