Allen + Roth WSWS-VS1672-1C Manual Del Usuario página 3

Repisa ventilada
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
Note: If shelf (A) needs cut to fit inside your closet space, cut only one side of the shelf and do not
use a hacksaw. It is recommended you hire an insured remodeler for this type of installation.
1. Using a stud finder (not included), find 3 stud
locations in the wall and mark them with a pencil (not
included). Draw a level line at the desired installation
height for shelf (A).
2. Secure Wall Brackets
(Item #0060506,
sold
separately) to the wall with M4 x 45 mm screws
provided with
brackets.
To secure the shelf (A) to a
side wall, use Side Bracket (Item #0060535, sold
separately) as a guide and mark screw hole locations
with a pencil. Drill 3/8 in. diameter pilot holes at least
2-1/2 inch deep at marked locations, then insert wall
anchors provided with Side Bracket into the holes
until they are flush with the wall. Attach Side Bracket
using M4 x 45 mm screws provided with the bracket.
Note: The Side Bracket should be positioned
15-1/2 in. away from the corner.
3.
Rest shelf (A) on top of
Wall Brackets and Side
Bracket, securing with M4 x 25 mm screws provided
with both brackets.
4. If you need to secure the shelf (A) to another
shelf (sold separately), attach Corner Bracket (Item
#0060596, sold separately) to shelf (A) using a
M4 x 25 mm screw provided with the bracket. Rest the
other shelf onto the Corner Bracket with two
M4 x 25 mm screws
provided with the
bracket.
1
2
Wall bracket
M4 x 45 mm
screw
Wall anchor
Side bracket
3
A
Wall bracket
Side bracket
M4 x 25 mm screw
4
Shelf
A
M4 x 25 mm screw
Corner bracket
M4 x 25 mm screw
Lowes.com/allenandroth
4
CARE AND MAINTENANCE
• Periodically check to make certain all components are properly positioned, free from damage and
firmly connected.
• Use a soft, clean cloth that will not scratch the surface when dusting.
• Never use water to clean the furniture as it may damage to the finish.
• Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
• In the event the furniture is stained or otherwise damaged during use, it is recommended
you call a professional to repair the furniture.
• Keep furniture away from direct sunlight as it may damage the finish.
• It is best to keep the furniture in a controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
One end of the shelf
The closet space is larger
is floating.
than 6 ft.
The shelf cannot be
The closet space is smaller
installed inside the
than 6 ft.
closet.
The shelf is tilting.
The wall brackets and shelf
brackets are not installed at
the same level.
WARRANTY
This product is warranted to the original purchaser. If there is a failure in this unit due to defects in
materials or workmanship, the manufacturer will repair or replace this item at our discretion without
charge. Warranty is void if product has been assembled incorrectly, misused, abused by
overloading, altered in any way or damaged due to accident. This warranty is not transferable and
does not cover chipping, flaking, scratches, rust, dents, or other damages to the surfaces of this
product. Responsibility of the manufacturer is limited to repair or replacement of this product. The
manufacturer is not responsible for consequential, incidental, or other damages or losses resulting
from product failure.
This warranty is in lieu of all other expressed warranties. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights and you may have other rights which vary from state
to state.
CORRECTIVE ACTION
1. Buy corresponding shelf bracket and wall
bracket (sold separately).
2. Replace the shelf with a longer shelf of a
similar finish and style.
1. Shorten one side of the shelf. Hire an
insured remodeler for installation.
2. Replace the shelf with a shorter shelf of a
similar finish and style.
Use a quality level to ensure the brackets
are leveled with each other.
Printed in Vietnam
allen + roth
is a registered trademark of
®
LF, LLC. All rights reserved.
Lowes.com/allenandroth
5

Publicidad

Tabla de contenido
loading

Tabla de contenido