Thermador Wok Ring SWOKRINGF Guia De Inicio Rapido

The Thermador Wok Ring is compatible with the following Thermador products:
5-Burner, Center Grate
Wok Ring Placement
WARNING:
• Failure to follow these instructions could result in
SERIOUS BURNS to the person(s) cooking and/
or person(s) in the immediate area of cooking.
• The Thermador Wok Ring must be installed
correctly to ensure its stability on the cooktop.
Read carefully, understand completely, and
follow closely the included instructions before
you attempt to cook using the Thermador Wok
Ring.
• The Thermador Wok Ring is designed for use
only with a round bottom wok. Do not use a flat
bottom wok on the Thermador Wok Ring.
• The Thermador Wok Ring is designed for use
only with select models of Thermador cooktops.
Read the included instructions to find out if your
cooktop can accommodate the Thermador Wok
Ring.
Wok Ring
Model: SWOKRINGF
SGS304FS, SGS365FS, SGS305FS, SGSX365FS, SGSX305FS
BACK
4-Burner, Right-Front Grate
Wok Ring Placement
Placing Wok Ring on Grate
For four-burner models: The Thermador Wok Ring is for
use on the right-front grate position only.
For five-burner models: The Thermador Wok Ring is for
use on the center grate only.
NOTE:
Do NOT place or remove the wok ring until the used grate
and wok ring are cool. Use with a round bottom wok up to
16".
1. The wok ring has four wok supports on the top and
three pronged feet on the bottom.
2. The wok ring has one pronged foot that is located
under a wok support. Be sure that this pronged foot
is always located at the back towards the rear of the
grate.
3. Align the pronged feet over the grate fingers as shown
in the graphics above to prevent the wok ring from
sliding off the grate.
BACK