Kohler K-11370 Manual De Instrucciones página 5

4. Anchor Installation
NOTE: You may need to disassemble some of the accessories. Some
accessories will be packed with the wall plate installed in the post.
Loosen the setscrew and remove the wall plate if needed.
Press and hold the legs of a wall anchor (provided) together and
insert the wall anchor legs into the hole. Insert all wall anchors
into the pre-drilled mounting holes.
With a hammer, carefully tap each wall anchor until they are
flush with the finished surface.
If the wall anchor was inserted into a space between the studs, it
will be necessary to spread the wall anchor legs.
To spread the anchor legs, insert a thin long object, such as a
finishing nail, into the wall anchor hole.
Ensure that the wall anchors are flush with the finished surface.
5. Wall Plate Installation
Orient the wall plate with the large slotted mounting hole up and
the smaller hole down.
Secure the wall plate with the supplied panhead screws.
Repeat at each wall plate location.
Kohler Co.
Install the Wall Plate
Large
Anchor Mounting Hole
Wall
Plate
Mounting
Hole
5
Panhead
Screws
1035699-2-A