Signing On The Hob; Checking Whether The Cooker Hood Is Signed On Or Signed Off; Signing Off - Miele Conactivity XKM 2000 DA Instrucciones De Montaje E Instalación

Ocultar thumbs Ver también para Conactivity XKM 2000 DA:
Tabla de contenido

Publicidad

en - Establishing communication

Signing on the hob

^ Please refer to the fitting and
installation instructions supplied with
communication module
XKM 2000/2100 KM*** for information
on how to sign on the hob.
The hob can only be signed on after the
signing on of the cooker hood is
complete.
Automatic mode will be active a few
seconds after completing the signing
on procedure.
Checking whether the cooker hood is
signed on or signed off
If you want to check whether the cooker
hood is signed on or signed off:
^ Switch off the fan and the hob
lighting.
^ Press the control for the run-on option
"–" for approx. 10 seconds. The
first power level indicator lamp will
light up in the display.
^ Then press in turn –
– the "-" control (Sensor "1")*.
– then the "+" control (Sensor "4")*,
– then the control for the hob lighting
"n" **.
If the automatic mode has been
activated, the indicator lamps for fan
power levels "II" and "III" will light up
continuously.
If the automatic mode has not been
activated, the indicator lamps for fan
power levels "II" and "III" will flash
simultaneously.
66
^ Press the control for the run-on option
"–" to come out of the checking
mode. All the indicator lamps will go
out.
If communication cannot be
established even although the cooker
hood and the hob have been signed
on, both appliances must be signed
off and then signed on again.

Signing off

To sign off the cooker hood:
^ Switch off the fan and the hob
lighting.
^ Press the control for the run-on option
"–" for approx. 10 seconds. The
first power level indicator lamp will
light up in the display.
^ Then press in turn –
– the "-" control (Sensor "1")*.
– then the "+" control (Sensor "4")*,
– then the control for the hob lighting
"n" **.
If automatic mode has been activated,
the indicator lamps for fan power levels
"II" and "III" will light up continuously.
^ Press the "-" control to deactivate
automatic mode.
After the signing off process has been
completed successfully, the indicator
lamps for fan power levels "II" and "III"
will flash simultaneously.
^ Confirm signing off with the control
for the run-on option "–". All the
indicator lamps will go out.

Publicidad

Tabla de contenido
loading

Tabla de contenido