Technical Specifications - SOUNDMASTER highline S-180 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Minimum separation from other devices
To avoid interference, maintain the following distances
between system components (wireless main unit and
wireless speakers) and other electronic devices that use the
same radio frequency (2.4GHz band).
Set-UP
In order to configure the S180 wireless speakers to work with an existing wireless main unit you must first pair
the speakers and the main unit.
All further instructions please follow on page "Speaker Pairing and Adding Additional Speakers" at main
unit instruction manual.
Note:
Only the RIGHT speaker has an IR sensor for receiving remote control commands. The remote
control should be pointed towards the right speaker for best performance.
Please note that bright sunlight or room lighting may interfere with the remote control operation.
Troubleshooting
No sound is heard
Volume is set too low or MUTE is ON. Increase volume level or release Mute.
Headphones are connected.
Speakers have become un-paired. Follow speaker paring instructions on main unit introduction
manual.
You are adding new speakers to the system and they are not paired. Follow speaker paring
instructions on main unit instruction manual.
Wireless speakers are located too far from the wireless main unit. The normal operation range is
about 100 ft / 30 m indoors. Move the speakers of the wireless main unit to reduce the operating
range.
Red "Link" LED on speakers is flashing
Wireless speakers are located too far from the wireless main unit. The normal operating range is
about 100ft / 30m indoors. Move the speakers of the wireless main unit to reduce the operating range.
The wireless main unit or wireless speakers are too close to interfering devices.

Technical Specifications

1. General
Electrical supply:
Power requirements of wireless speaker unit:
Dimensions of wireless speaker unit:
Weight of wireless speaker unit:
2. Transmission section
Number of RF channels:
Channel frequency:
Channel Spacing:
Rx sensitivity:
Transmission Power:
Number of pairing Rx:
3. Speaker system
Output power
Impedance:
Copyrights by Woerlein GmbH, D-90556 Cadolzburg, Germany
Any technical changes without any further announcement
3
CH1: 2412MHz
CH2: 2438MHz
CH3: 2464MHz
26 MHz
-83dBm
18 dBm (Typical)
25
15W/CH (THD<1%)
4Ω
100-240V~50/60Hz
15V 2A
345 (L) x 118 (W) x 158 (H) mm
1.7kg
We hereby confirm that model DISC 180 / S 180 is
conform with regulations 1999/5/EC. The EC-
declaration can be requested at the following address:
Wörlein GmbH
Gewerbestraße 12
D 90556 Cadolzburg
Tel:
+ 49 9103 / 71 67 0
Fax:
+ 49 9103 / 71 67 12
Email:
info@woerlein.com

Publicidad

Tabla de contenido
loading

Tabla de contenido