Dorel 63148SLV1E Manual De Montaje página 19

Change Displayed Value
The displayed height value usually reads the current height of the frame measured from floor to top
support.
The displayed values are either in inch or centimeter. The displayed value can be changed without
adjusting the frame height. (Normally this is done to include the thickness of the table top, meaning
the measured height from floor to top edge of the table top.) To change the height value, please fol-
low these instructions:
1. Determine the value you want to add to the displayed value.
2. Press the button S KEY.
-> The display shows S –
3. Press and hold DOWN for five seconds.
-> The displayed height starts flashing.
4. Press the button UP or DOWN until the required value is shown in the display.
5. Press the button SAVE.
6. The status bar flashes in green and the display now indicates the table height according to
your setting.
Restarting the Control Unit
If an initialized control units needs to be resetted please follow the next steps:
1. Adjust the frame into lowest position, to do so press DOWN until the frame stops automatically.
2. Release DOWN.
3. Now press and hold DOWN for 5 to 8 seconds. The control unit will immediately recalibrate and
finish the reset mode. (During the calibration process the frame will move a couple of
millimeters down and then up again.)
4. You have restarted your control unit and can operate the frame normally.
Change Displayed Value Unit
The displayed height value unit typically depends from the country where you are living in. It is either
displayed in inch or centimeter.
The displayed value unit can be changed, to match your need. To do so please follow these instruc-
tions :
1. Press and hold the S KEY for 5 seconds.
-> The display shows " S – 1"
2. This indicates that you have activated the settings mode. Navigate through the mode menu by
pressing UP or DOWN .
3. Choose " S – 1" to use centimeters as unit measure and press the Save Key. Or choose " S – 2" to
use Inches as unit measure and press the Save Key. The status bar flashes green as confirmation.
4. Depending on the previous setting, the displayed height value is now either in inch or centimeter.
English
19