Preparing Cabinet Opening - LG SIGNATURE LUDP890 Serie El Manual Del Propietario

Preparing Cabinet Opening

This dishwasher is designed to fit a standard
dishwasher opening. An opening may be needed
on both sides to route plumbing and electrical
connections.
• To ensure proper drainage, install the
dishwasher no more than 12 ft. (3.65 m) from
the sink.
• The location must have sufficient space for the
dishwasher door to open easily and provide at
least 0.1" (2 mm) between the dishwasher and
the cabinet sides.
• If installing the dishwasher in a corner, leave a
minimum of 2" (50 mm) between the dishwasher
and the adjacent wall.
• The adjacent wall must be free of obstructions.
• For flush installations only, you may remove the
cabinet brace inside the cabinet.
a
1
Select a location as close to the sink as
possible for easy connections to water supply
line, drain hose and electrical connection.
2
To allow for proper clearance of plumbing and
electrical, use the template included with the
literature to determine the clearance on the
side of the cabinet where the cabinet meets
the back wall. Using a 2
drill a hole in the target area as shown on the
template.
3.5 ''
2.5 ''
WARNING
• Installation damage is not covered by the
warranty, and leaks caused by improper
installation may result in property damage.
• Do not use existing holes unless they are in
the target area.
• Failure to properly locate the hole for the
water and drain lines may prevent the
dishwasher from installing flush with the
cabinets and could result in kinked, pinched,
crushed, stressed or damaged lines.
INSTALLATION
/ " diameter hole saw,
1
2
4 ''
15