Tools Required - Cooper Lighting RSWPD Instrucciones De Instalación

WaveLinx Wireless
INSTALLATION
This lighting fixture has been shipped complete with one
of several mounting options. Please follow the installation
instructions specific to the catalog part that you ordered.

Tools required

Ratchet, a shallow 3/4" socket and 1/4 hex nut driver;
3/8" Allen drive for 1/2" inch bolt; #2 Phillips head screw driver;
torque wrench.
Pole Mount (Figure 1)
The housing mounts standard to a square pole using the toggle
bolts supplied. A round Pole mount adapter (included) mounts
housing to a 4"- 6" round pole. A 4" pole is the minimum
recommended.
1. Mount toggle bolts to pole by inserting the toggle into the
pole. If using a round pole mount adapter (optional) shown,
install toggle through the 1/2" holes first. Cinch up collar
against pole and remove finger tabs. Squeezing the tabs
will shear them at the cinch collar. (Figure 2)
2. Fasten housing mounting plate, slot facing downward, with
2 x ¼"-20 hex bolts as shown. Tightening torque shall be 50
in-lbs. (Figure 3)
3. Route and attach wires per wiring diagram. Feed wires
through the mount plate and feed wires through the pole.
N ote: 3' of leads are provided extending outside the housing.
(Figure 4)
4. Insert wires into the pole as you place the housing on the
mount plate. The bracket on the inside fixture and lanyard
allow for hanging the housing during installation.
N ote: Do not to pinch the lanyard cable when installing the
housing. Once the housing is in position, tighten using
(2) set screws. Tighten until screw is bottomed out.
5. Verification. Once powered a green LED color indicates
that the Integrated Sensor has not yet been paired with
a Wireless Area Controller. If the LED blinks white, this
indicates that the sensor has been previously paired with a
Wireless Area Controller. See the WaveLinx User Manual for
information on resetting the pairing.
Square Pole Round Pole
Mount Mount
Figure 1
IB503092ML page 2
September 2020
2-1/16" [53mm]
30" [760mm]
Maximum
4-9/16"
[117mm]
2-1/2"
[64mm]
1-1/2" [38mm] (2) 1/2" [13mm]
Diameter Hole Diameter Holes
RSWPD - Outdoor Sensor Extender/Multiplier
Collar side
flush
Fingertabs
aligned top
and bottom
After tabs
broken flush
Figure 2
Figure 3
Lanyard
Hook Tab
Housing
Mounting
Screws
Figure 4
Shown with
tabs before
breaking off
UP
1/4-20 X 1.5"
Hex Bolt
Wall Plate with
Gasket Installed
Slot Facing Down
Lanyard
Hook Tab
Housing
Mounting
Screws
www.cooperlighting.com