Philips MiniVac FC6132/01 Manual De Instrucciones página 14

English
1
Problem
The vacuum
cleaner does not
work properly
when the floor
nozzle (FC6132),
the hose (FC6130),
the brush tool or
the crevice tool is
attached.
I cannot store
the appliance
upright (FC6132).
Solution
Check if the floor nozzle, the hose, the brush
tool or the crevice tool is blocked. If this is the
case, remove the obstruction.
Check if the dust compartment is full. If it is full,
empty it (see chapter 'Cleaning').
Check if the filter unit is clogged. If it is clogged,
remove the filter unit and clean the inner and
outer filter (see chapter 'Cleaning').
Make sure that the floor nozzle is attached. The
appliance can only stand upright when the floor
nozzle is attached.
Check if dirt is stuck to the bottom of the floor
nozzle. If there is, remove the dirt.
Check if the floor is hard, flat and stable. When
you store the appliance upright, always put it on a
hard, stable and flat surface.
Check if the ridges on the floor nozzle are
aligned properly with each other. If not, align the
ridges properly.