Device Description - Leister VULCAN SYSTEM Manual De Instrucciones

Device description

7
6
5
1 Cable gland for mains connection
(mounted ex works)
2 Locking screw for frequency converter
(mounted ex works)
3 Locking screw for alarm relay
(mounted ex works)
4 Locking screw for interface
(mounted ex works)
5 Cable gland for frequency converter
(enclosed in the connection housing)
6 Cable gland for alarm relay
(enclosed in the connection housing)
Preparation
• Remove VULCAN SYSTEM from the packaging.
• Remove the connection housing cover (12) by loosening the screws (13).
• Remove warning slip,
• Remove locking screws (mounted ex works) for the frequency converter (2), alarm relay (3) and interface (4).
• Mount the enclosed cable glands for the frequency converter (5), alarm relay (6) and interface (7), if
required.
• If no interface or FU / FC (frequency converter) is used, the cable glands (5 / 7) must be removed and the locking
screws (2 / 4) mounted.
20
12
11
10
13
4
3
8
9
2
read carefully and keep at hand for consultation.
1
16
7 Cable gland for interface
(enclosed in the connection housing)
8 Flange ø 60 mm
9 Air slide
10 Potentiometer for temperature setting
11 Display
12 Connection and housing cover
13 Screws for connection housing
14 Heating element tube
15 Mounting base
16 Blower motor
15
14