Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PORTABLE COMPRESSOR
The built-in 12 volt DC compressor is the ultimate compressor for all vehicle tires,
trailer tires and recreational inflatables. A nozzle adaptor is supplied that screws
onto the end of the Sure Fit
nozzle at the free end of the compressor hose.
®
The compressor hose with tire fitting is stored in the compressor hose storage
compartment. Refer to the "Features" illustration for locations of compressor hose.
The Compressor Power Button and Compressor Pressure Control Buttons are located
on the control panel on the front of the unit.
Before proceeding, check the unit's battery status on the LCD screen. Four solid bars
in the battery icon indicates a full battery. When the battery level is nearly empty
with only one solid bar, the unit MUST be recharged before use or the unit's built-in
low voltage protection will activate. The empty Battery Status Icon will flash for a
short period of time before automatic shut down.
The compressor may be used by removing the air hose from the storage hatch and
if required, fitting the nozzle adapter to the air hose. The compressor is capable
of inflating up to 120 pounds per square inch (psi) pressure. The compressor can
operate long enough to fill up to 3 average sized tires before the battery must be
recharged. Return hose to the storage compartment after use.
IMPORTANT: Make sure the Jump Starter Power Switch has been turned off before
attempting to use the unit as a Compressor.
WARNING –
TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
Follow all safety instructions found in the "Specific Safety Instructions For
Compressors" section of this instruction manual.
NOTICE –
TO REDUCE THE RISK OF PROPERTY DAMAGE:
When the compressor is operated at a low PSI, the unit may start in low and
gradually rev up. When the compressor is operated at higher PSIs, the unit may
operate normally for several minutes, then rev down for a few minutes before
returning to normal operation. This feature protects the unit from overheating
during normal use. In any event, do not operate compressor continuously for
extended periods of time (approximately 10 minutes, depending on ambient
temperatures), as it may overheat. This could damage the compressor. If the
compressor must be operated for longer periods: every 10 minutes press the
Compressor Power Button to turn the compressor off, then restart after a cooling
down period of approximately 30 minutes.
In any event, the compressor will automatically shut down after operating
continuously for 10 minutes.
Inflating Tires or Products With Valve Stems
1. Screw the Sure Fit
®
nozzle onto the valve stem. Do not overtighten.
2. Press the Compressor Power Button. A beep will sound and the backlit LCD
screen will display the following:
The Compressor Icon will light and the digital display will alternately show the
flashing pre-set psi value (that was last set by the compressor pressure control
buttons) and the current pressure of the item being inflated (which will light
solid).
3. Press the "+" and "–" Pressure Control Buttons to set the desired pressure from
a range pre-set values (between 3 and 120), which will display on the backlit
LCD screen. The unit will sound a beep with each press of the buttons (holding
the button speeds up the upward or downward value selection). Once the
desired pressure has been entered, release the button and the flashing digital
display will show the new selected pressure, as follows:
The new selected value is now stored in the unit's memory until it is manually
reset.
4. Press the Compressor Power Button once more to begin inflating. The
Compressor Icon will flash and the digital display will only show the current
pressure value (which will light solid) to indicate the compressor is activated.
Monitor the pressure on the LCD screen.
IMPORTANT NOTE: To interrupt during inflation, press the Compressor Power
Button again.
5. When desired pre-set pressure is reached, the compressor will automatically
stop.
PPRH7DS _Type2_ManualENSP_071921.indd 10-11
PPRH7DS _Type2_ManualENSP_071921.indd 10-11
6. Press the Compressor Power Button again to turn off the unit.
7. Unscrew and remove the Sure Fit
®
nozzle from the valve stem.
8. Allow the unit to cool, then recharge before storing away.
9. Store the compressor hose and Sure Fit
®
nozzle in storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of the nozzle adapter.
1. Screw the nozzle adapter into the Sure Fit
nozzle. Do not overtighten.
®
2. Insert the nozzle adapter into item to be inflated.
3. Follow steps 2 through 4 of the "Inflating Tires or Products With Valve
Stems" section.
IMPORTANT: Small items such as volleyballs, footballs, etc. inflate very rapidly.
Keep this in mind when setting pressure. Take extra care not to over-inflate.
4. When the desired pressure is reached, the compressor will automatically stop.
Press the Compressor Power Button again to turn off the unit.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the nozzle adapter from the Sure Fit
nozzle.
®
7. Allow the unit to cool, then recharge before storing away.
8. Store the compressor hose, Sure Fit
®
nozzle and nozzle adapter in the storage
compartment.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, we recommend that the battery is
charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer
surfaces of the unit with a soft cloth.
There are no user-replaceable parts. Periodically inspect the condition of adapters,
connectors and wires. Contact manufacturer to replace any components that have
become worn or broken.
Battery
Please be advised that the battery is designed to last the service life of
the unit and is not replaceable, removable or serviceable. Service life is
dependent on a number of factors including but not limited to the number of
recharge cycles, and proper care and maintenance of the battery by the end user.
Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid
battery, which must be disposed of properly. Recycling is
required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Unit will not charge
• Make sure the AC/USB power button has been pressed to turn the inverter off.
• Make sure a suitable gauge extension cord is properly connected to both the unit
and a functioning AC outlet.
Unit fails to jump-start
• Make sure the unit is not being operated in the Compressor mode.
• Make sure unit's Jump Starter Power Switch is in the on position.
• Make sure a proper polarity cable connection has been established.
• Check that unit has a full charge. Recharge unit if necessary.
120 volt AC outlet will not power appliance
• Make sure the AC/USB power button has been pressed to turn the inverter on.
• Make sure yo u have followed all the steps in the 120 AC portable power supply
instructions carefully.
• Make sure the appliance being powered does not draw more than 500 watts
• Refer to the important notes included in that section that explain common
problems and solutions.
• Check that unit has a full charge. Recharge unit if necessary.
10
12 volt DC accessory outlet will not power appliance
• Make sure the the appliance does not draw more than 5 amps.
• Check that unit has a full charge. Recharge unit if necessary.
USB power port will not power appliance
• Make sure that the total draw of the USB device plugged into the USB port does
not exceed 2.1A.
• Make sure the AC/USB power button has been pressed to turn the USB ports on.
• Some USB-powered household electronics will not operate with this USB charging/
power port. Check the manual of the corresponding electronic device to confirm
that it can be used with this type of USB charging/power port.
• Check that unit has a full charge. Recharge unit if necessary.
LED area light does not come on
• Make sure the area light power button has been pressed to turn the area light on.
• Check that unit has a full charge. Recharge unit if necessary.
Portable compressor will not inflate
• Make sure the unit is not being operated in the Jump Starter mode.
• Make sure the compressor power button has been pressed to turn the compressor
on.
• Make sure the Sure Fit
nozzle connector is securely screwed on to the valve stem
®
when attempting to inflate tires; or that the nozzle adapter is securely screwed
into the Sure Fit
nozzle connector and is inserted properly into the item to be
®
inflated on all other inflatables.
• The compressor may be overheated. Press the compressor power button to turn the
compressor off. Restart after a cooling down period of approximately 30 minutes.
• Check that unit has a full charge. Recharge unit if necessary.
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at 1-877-571-2391.
The use of any accessory not recommended for use with this appliance could
be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR HOME USE WARRANTY
The manufacturer warrants this product against defects in materials and
workmanship for a period of ONE (1) YEAR from the date of retail purchase by the
original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return the
product to the manufacturer for repair or replacement at manufacturer's option.
Proof of purchase may be required by manufacturer. (2) Return the product to the
retailer where product was purchased for an exchange (provided that the store is a
participating retailer). Returns to retailer should be made within the time period of
the retailer's return policy for exchanges only (usually 30 to 90 days after the sale).
Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during shipping;
alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you
may have other rights which vary from state to state or province to province. This
product is not intended for commercial use.
Be sure to register your product at https://www.baccusglobal.com/registration to
receive important product information, special promotions and offers, and more.
SPECIFICATIONS
Boost Ampere:
12V DC, 700A instant
Battery type:
Maintenance-free, sealed lead acid, 12V DC
AC input:
120V AC, 60Hz, 14W
Area light:
3 white LEDs
USB port:
5V DC, 2.1A
DC accessory outlet:
12V DC, 5A
Dual 120V AC outlets:
120V AC, 60Hz, 500W continuous
Compressor maximum pressure:
120 PSI
Sure Fit
is a registered trademark owned by Baccus Global, LLC.
®
STANLEY
AND THE STANLEY
LOGO ARE
Imported by Baccus Global LLC,
®
®
REGISTERED TRADEMARKS OF STANLEY
621 NW 53rd St., Suite 450, Boca Raton, FL 33487
BLACK + DECKER INC. OR ONE OF ITS AFFILIATES,
www.baccusglobal.com 1-877-571-2391
AND ARE USED UNDER LICENSE.
RD071921
11
7/19/2021 11:11:00 AM
7/19/2021 11:11:00 AM
Publicidad
Tabla de contenido
