Using The Beard Styler Attachment Without Comb - Philips Norelco 6000 Serie Manual De Instrucciones

2
1

Using the beard styler attachment without comb

also use it to pre-trim any long hairs before
shaving for a more comfortable shave.
The length settings on the beard styler
attachment correspond to the remaining hair
length after cutting and range from 1 to 5mm
(3/64 - 3/16in).
1 Attach the beard styler to the product
('click').
2 Slide the comb straight into the guiding
grooves on both sides of the beard styler
attachment ('click').
3 Press the length selector and then push it
to the left or right to select the desired hair
length setting.
4 Switch on the product.
5 Move the product upwards while you exert
gentle pressure. Make sure the front of the
comb is in full contact with the skin.
If cut hairs accumulate in the comb, switch
the product off, remove comb and blow
and/or shake hair out of the comb.
6 Clean the attachment after use.
You can use the beard styler attachment
without the comb to contour your beard,
mustache, sideburns or neckline to a length of
0.5mm (1/32 in).
21
English