Using The Beard Styler Attachment Without Comb - Philips NORELCO SP9860 Prestige Manual Del Usuario

20
English
2
1

Using the beard styler attachment without comb

2 Slide the comb straight into the guiding
grooves on both sides of the beard styler
attachment ('click').
3 Press the length selector and then push it
to the left or right to select the desired hair
length setting.
4 Switch on the product.
5 Move the product upwards while you exert
gentle pressure. Make sure the front of the
comb is in full contact with the skin.
If cut hairs accumulate in the comb, switch
the product off, remove comb and blow
and/or shake hair out of the comb.
6 Clean the attachment after use.
You can use the beard styler attachment
without the comb to contour your beard,
mustache, sideburns or neckline to a length of
0.5mm (1/32 in).
1 Pull the comb off the beard styler
attachment.
Note: Grab the comb in the center to pull it
off the beard styler attachment. Do not pull
at the sides of the comb.
2 Switch on the product.