Cleaning The Beard Styler Attachment; Replacing The Shaving Unit Razor Heads - Philips NORELCO YS524 Manual De Instrucciones

English
22
_YS524.indd 22

Cleaning the Beard Styler Attachment

1 Remove the bear styler comb.
2 Rinse the beard styler attachment and comb
under hot water.
3 Shake off excess water and allow to air dry
thoroughly.
Tip: Lubricate the trimmer teeth with one drop
of mineral oil every 6 month.

rEplacing thE shaving unit razor hEads

- Replace the Shaving Unit razor heads every 12
months for optimal results.
- Replace with RQ32 Philips Norelco razor heads
only
1 Follow steps 1-4 under 'Extra-thorough
Cleaning Method' section.
2 Remove the shaving heads and place new ones
in the shaving head holder making sure the two
wings of the shaving heads fit exactly into the
recesses.
3 Reattach the retaining ring (1) by turning it
the opposite direction of the arrows on the
retaining ring (2).
Make sure the four wings of the retaining ring
are located exactly under the recesses of the
shaving head holder.
11/12/12 11:54 A