Troubleshooting - BLACK&DECKER JS650L Manual De Instrucciones

JS650L Manual - LAG.qxd
the workpiece and saw through this sandwich.
SAWING METAL
- Be aware that sawing metal takes much more time than sawing wood.
- Use a saw blade suitable for sawing metal.
- When cutting thin metal, clamp a piece of scrap wood to the back surface of the
workpiece and cut through this sandwich.
- Spread a film of oil along the intended line of cut.
P ro b l e m
• Unit will not start.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
I M P O RTA N T: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
p a r t s .
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center.
WARNING: The use of any accessory not recommended for use with this tool could be
T E C H N I C A L S P E C I F I C ATIONS OF LASER:
Laser diode wavelength:
Laser Class:
Working Range:
B a t t e r i e s :
Voltage:
Operating temperature:
Wa t t s
H e r t z
S P M
2006.7.26 5:04 PM Page 9

TROUBLESHOOTING

P o s s i b l e C a u s e
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
633-670nm (red color)
Class II
Up to 6 inches (152mm) line span (depends on light
c o n d i t i o n s )
2 A A A alkaline (included)
3 Vo l t s
41°F (5°C) - 104° F (40°C)
6 6 0 W
5 0 - 6 0 H z
800-3200 spm
9
P o s s i b l e S o l u t i o n
• Plug tool into a working
o u t l e t .
• Replace circuit fuse.
(If the product repeatedly
causes the circuit
fuse to blow, discontinue
use immediately and
have it serviced at a Black
& Decker service center or
authorized servicer. )
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer. )
• Have cord or switch
replaced at Black &
Decker Service Center or
Authorized Servicer