Bohle DIAMANTOR TG H200 Instrucciones De Uso página 11

With the Bohle DIAMANTOR band saw attachment
you can transform almost any glass grinder into a
fully functioning glass band saw in just a few steps.
The DIAMANTOR saw blade is diamond coated all
around, allowing even complicated shapes or extre-
mely small inner radii to be sawn. The self-cente-
ring run makes guides for the saw blade unnecessa-
ry. No separate electrical or coolant supply is requi-
red.
Band saw
attachment with
worktable and
saw blade
Coolant sponge
Hexagon key
Drive cone
Fastening band
Adjustment gauge
Sleeve
01 Preparation of the
Grinder
1) Press the provided sleeve into the grid plate of
the grinder. For the exact position for your particu-
lar grinder please refer to the attached drawings.
GLASTAR grinders do not require the sleeve. It is a
good idea to permanently mark the corresponding
grid opening with a waterproof marker.
2) Replace the diamond grinding head with the pro-
vided drive cone. By using the provided adjustment
gauge, you will get the correct height (height from
grid plate to lower edge of drive cone 11 mm).
GB
11