Sawing Glass; Sawing Other Materials - Bohle DIAMANTOR TG H200 Instrucciones De Uso

8) Place the new saw
blade onto the middle of
the lower band roller.
Push down the upper
band roller and put the
saw blade onto it as well.
9) Manually turn the
lower roller approx. 2-3
rotations in the running
direction. This will auto-
matically centre the saw
blade. The tension spring
keeps the saw blade
under tension. Turn on
the machine to check the
running position of the
saw blade. The saw
blade should run approx.
5-10 mm from the edge
of the lower roller. The position of the saw blade
can only be corrected by carefully turning the knur-
led nut on the back side of the saw. Please run a
few tests to set the desired position. Then turn the
machine off again.
10) Without pressure,
tighten the eccentric
below the rocker bar.
Finally, put the hood and
the worktable back in
place and tighten the
fastening screws.

04 Sawing Glass

11) Set your glass on the worktable. Guide the glass
along the saw blade using gentle pressure, always
sawing toward the transparent blue side. When
sawing curves, turn the glass smoothly without jer-
king! The glass should be pressed against the saw
blade only enough that the saw blade does not get
pushed from the roller. Familiarize yourself with the
correct sawing pressure by first sawing some trial
pieces. At the end of a cut, stop pressing against
the saw blade so that the glass does not splinter.
05 Sawing other
Materials
For other materials the same applies as for glass.
However, the sawing pressure may be different. Be
sure that you always keep the object you are
sawing firmly on the worktable.
GB
13