Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How to use your Braun No touch + forehead
Remove cap
1
Power on
2
Press and release the power
button once. Backlight will
come on and the start up
sequence starts.
Ready
When the device is ready and correctly
positioned, a horizontal line of dashes
("---") will appear on the screen.
3
Position
Position device on or up to 2
inches (5 cm) away from the
center of the forehead, just
between the eyebrows.
For No
touch readings, the yellow
guidance light will show you
where you are aiming. If the
eyebrow area is covered with hair,
sweat or dirt, please clean the
area and then wait 10 minutes to
improve the reading accuracy.
It is important to hold the thermometer and
the forehead steady during measurement.
Movement will impact the temperature reading.
6
0 - 2"
Yellow light
will show
you where
you are
aiming.
0 - 2"
(0-6 cm)
Take temperature
4
Press the temperature button (you can press
and hold the button or press and release it).
When the device is placed correctly, the screen
displays a dashed line animation while it takes a
reading. After the animation sequence (under 2
seconds), the display shows the temperature. The
appropriate backlight color is displayed on the
screen and the confirmation beep is heard.
If the device is positioned too far away from the
forehead, it will prompt you to move closer by
displaying the letters "FWD." Slowly move the
device toward the forehead until the dashed
line animation starts and a reading is displayed.
Read temperature
5
Remove the device and
read the temperature.
For no backlight and green
backlight readings, you will
hear a single long beep for 2
seconds. For yellow and red
backlight readings, you will
hear 10 short beeps.
To repeat
Go to step 3.
To turn off
6
Press the power button to turn off. Device will also shut off
automatically after 60 seconds of no use.
0 - 2"
(0-6 cm)
0 - 2"
(0-6 cm)
7
Publicidad
Tabla de contenido
