Gedore DREMASTER Z Instrucciones De Manejo página 12

Calculation of the torque setting for divergent depth gauges in
respect of the spigot end adaptor:
The new torque setting M
following formula:
l l l
k CZ zert
M = The torque which must be set on the torque
xW
wrench scale.
M = The torque with which the screw or nut
A
is to be tightened.
l = The distance between the center of the torque
WZ
wrench adaptor's locking pin and the center of
the handle (see table in section 7).
= The distance between the center of the torque
l
CZ
wrench adaptor's locking pin and the center of
the screw or nut (also referred to as tool
accessory depth gauge).
l = depth gauge specified in the certificate.
zert
= adaptor correction dimension.
l
k
14
EN
is calculated according to the
xW
M
 l
M

A
 l
xW
l
k WZ
WZ