Control Panel; Turning The Device On - Bartscher NT 501 Instrucciones De Uso

Control panel

Upper heating coil
temperature dial
Lower heating coil
temperature dial

Turning the device on

•
Turn the device on using the ON/OFF switch. The internal light will come on.
•
Set the temperature using the temperature dials, with a separate dial for each baking
chamber.
•
Each baking chamber in the pizza ovens from the NT series (except 2002027) has
two heating coils: one is under the Schamotte stone, and the other in the upper part
of the pizza oven. The coils are regulated using the temperature regulators at the top
and bottom.
NOTE!
•
Pizza oven 2002027 has only one baking chamber, divided into
two sections by Schamotte stone.
This pizza oven has 3 heating coils and 3 temperature regulators.
The upper temperature dial is for adjusting the upper coil, the
lower one – for adjusting the lower coil.
The central coil is located directly underneath the Schamotte
stone in such a way that it serves as the lower coil for the upper
chamber, and the upper coil for the lower chamber. The middle
temperature dial regulates its temperature.
•
Set the desired temperature. The lower and/or upper heating coil
control lights will come on.
•
The pizza oven temperature range is 0 ° C - 400 ° C . We recommend
a setting of 300 ° C - 400 ° C.
•
When the desired temperature has been reached the control light will go off. If the
temperature inside the baking chamber begins to fall, the control light will come on
again and the coil will heat up until the set temperature has been reached.
Upper heating coil
control light
Lower heating coil
control light
ON/OFF switch
- 25 -