Hilti IC-BLE Manual De Instrucciones Original página 16

Rated voltage
Rated current
Battery
Dimensions (L × W × H)
Operating temperature
Storage temperature
Signal range (can vary greatly depend-
ing on surrounding conditions)
4.2 Bluetooth
Communication standard
Frequency
Maximum emitted transmission power
5 Operation
5.1 Installing receiver module
Always use a screwdriver for tightening and loosening the securing screws. Tighten the securing
screws no more than hand-tight. Before engaging the threads, turn each screw a half-turn counter-
clockwise so that the screw is snug in the lead-in of the thread. This precaution helps prevent
excessive wear of the screw head and the screw boss.
1. Remove the 2 securing screws from the blanking cover on the vacuum cleaner.
2. Remove the blanking cover.
3. Plug the connector into the port.
▶ Note the coding of the plug-in connection.
▶ The connector is engaged.
4. Insert the receiver module into the mount.
5. Secure the receiver module with the 2 securing screws.
6. Hold the remote control unit in position on the suction hose.
7. Fix the remote control unit firmly in position with the rubber band for attachment.
5.2 Pairing remote control unit and receiver module
The remote control unit and receiver module in a set are paired ex-works. You can pair two products
manually, for example when you replace or retrofit either of the two components. Pairing mode is also
activated whenever you deactivate the BLE-Mute mode.
1. On each of the two products to be paired (remote control unit and receiver module), press the operating
button and hold both buttons down for 3 seconds.
▶ The LED indicator (on remote control unit and receiver module) flashes.
For a maximum of 30 seconds, the products search for a matching pairing partner. If there is no
matching pairing partner in range, pairing mode is aborted.
2. Wait until the pairing procedure has completed.
▶ Pairing has completed as soon as the LED indicator (on the receiver module) starts to pulsate.
5.3 Using remote control unit
The remote control unit enables on/off control of the vacuum cleaner at a distance. The rubber band for
attachment enables you to attach the remote control unit to the suction hose or a power tool. Make sure that
you do not obstruct grip surfaces or safety devices.
1. Set the vacuum cleaner to Bluetooth operation.
▶ Follow the instructions in the operating instructions for the vacuum cleaner.
12 English
IC-RC
3.3 V
50 mA
•/•
62 mm × 43 mm × 14 mm
−15 ℃ ... 50 ℃
−20 ℃ ... 70 ℃
30 m
Bluetooth® 5
2,404 GHz ... 2,480 GHz
4 dBm
2
IC-RM
3.3 V
20 mA
CR2032
40 mm × 37 mm × 21 mm
−15 ℃ ... 50 ℃
−20 ℃ ... 70 ℃
30 m
2321964
*2321964*