Ampro NEO FLEX TRUSS Manual De Usuario página 9

6. MASTER/SLAVE
OPERATION (via DMX cable)
When multiple NEOFLEX TRUSS units are used together,
Master/Slave mode enables the assignment of one master
unit and multiple slave units. The master unit can be oper-
ated in stand-alone mode or by IR6 infrared remote control.
The slave units should all be set to slave mode as described
below.
- Note: Slave units should be configured and connected
before linking to master unit.
SETUP AS BELOW:
Slave units:
Press MENU button until 3-CH or 8-CH is displayed
1.
2. Press ENTER
3. Set DMX address to d 1
4. Connect DMX cable from master unit to DMX In con-
nector Link following slave units in similar cable configuration.
Master unit:
Set to Auto or control with IR6 infrared remote.
1.
2. Link to slave units, beginning from the master DMX
Out connector.
BATTERY/BATTERY LIFE DISPLAY
- Rechargeable lithium battery.
- Up to 20 hours of use per charge (sing single colors)
- Aprox. 5 hours charge time
- iTRI RED indicator = Charging
- iTRI GREEN indicator = Fully Charged
IMPORTANT: Put the iTRI ON/OFF switch in the OFF po-
sition when recharging
IMPORTANT: Charge the iTRI for 24 hours continuously
before first use.
P. 9
NEO FLEX TRUSS
ENGLISH VERSION