Ryobi CNS-1801M Manual De Utilización página 4

GB
FR DE ES
SPECIFICATIONS
Voltage
Staple speed
BATTERY PACK
MODEL
(not included)
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
BPL-1820
CNS-1801M
BPL-1815
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
DESCRIPTION
1. Depth Adjustment knob
2. Trigger Switch
3. Handle
4. Activation Foot
5. Magaeine
6. Latches
7. Battery Pack (Not included)
8. Staples
9. Brads
10. Tabs
OPERATION
WARNING
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second issufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure
to do so could result in objects being thrown into
your eyes, resulting inpossible serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for nailing and stapling.
TO INSTALL BATTERY PACK (NOT INCLUDED)
(Fig. 2)
IT NL PT DK SE
18 V
40 shots/min
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
BC-1815S
BC-1800
FI NO RU PL CZ
English
Place on the the battery pack in the drill. Align the
Q
raised rib battery pack with the groove inside the drill.
Make sure the latches on each side of the battery
Q
pack snap into place and the battery pack is secured
in drill the before beginning operation.
CAUTION
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom
of the drill and latches into place properly.
Improper installation of the battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK (NOT INCLUDED)
(Fig. 2)
Locate the latches on the side of the battery pack and
Q
depress to release the battery pack from the drill.
Remove the battery pack from the drill.
Q
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
LOADING THE TOOL WITH STAPLES (Fig. 3-4)
Remove battery pack from the tool.
Q
Hold tool upside down; squeeze tabs and slide
Q
base open.
Place staples in channel, legs facing upward and
Q
close base.
Make sure the tabs are securely locked in place.
Q
Reattach battery pack to tool.
Q
LOADING THE TOOL WITH BRADS (Fig. 3-5)
Remove battery pack from the tool.
Q
Hold tool upside down; squeeze tabs and slide
Q
base open.
Place brads in the centre of the channel with "T" head
Q
sitting on the slot base. Close base while making sure
brad strip stays upright in channel.
1
HU RO LV LT EE HR SI SK GR TR