IMER M400 SMART Manual De Uso & Mantenimiento página 11

The power lines must be laid to prevent any possible damage.
Ensure that the electrical connection is protected against the risk of
water penetration in connectors. Only use connectors and couplings
equipped with spray guards.
Never use inadequate or makeshift electrical lines or cables without
earthing; if in doubt consult a specialised technician.
Repairs to the electrical installation must be performed exclusively by
specialised personnel Disconnect the machine from the power supply
before performing maintenance or repairs.
This machine was designed to provide the best performance and the
highest degree of safety: however, it is up to the operator to ensure this
safety, by taking due care during all work phases. The following are
recommended:
IMER INTERNATIONAL S.p.A.
M400 SMART
The M400 SMART has been constructed taking into account current
harmonised European safety standards.
According to the "machinery directive" 2006/42/EEC, all safety devices
have been installed with the aim of safeguarding the operator.
and protections that prevent access to moving or dangerous parts. All
envisaged to protect the operator (maintenance engineers, technicians
and others) from possible accidents cause by electrical discharge or
moving mechanical parts.
way is strictly prohibited.
The machine must be placed on a smooth surface that is at least as
large as its frame, or supported on its legs.
In the event of moving the saw, take care to lock the head by means
of the knob
(Fig.1, Ref.D), lock the carriage with its cotter pin (Fig.1, Ref.N) and lift
the machine by the handles machined into the frame (Fig.1, Ref.O)
after having shut off its power supply.
To open the legs, proceed as follows: raise the machine at the rear
(Fig.1, Ref.1), push the leg in the direction of the arrow (Fig.1, Ref.2)
to move the bolt (Fig.1, Ref.3) away from the stop, turn it to open it
(Fig.1, Ref.4) and snug the bolt into the slot (Fig.1, Ref.5). Now rest
the machine on the ground. Now do the same at the front end of the
machine. To close the legs, reverse the procedure.
The M400 SMART sawing machine weighs 77 Kg and can be moved by
hand, lifting it with the handles machined into its frame or with a hoist,
with ropes hooked into the indicated attachment points (Fig.1, Ref.P).
The wheels (Fig.1, Ref.Q) are an aid to loading the machine onto a truck
with a mobile platform.
The power supply line must be equipped with current overload protection
(e.g. thermal cutout) and protection against indirect contact (e.g. residual
system. The size of the power cable wires must be based on operating
current and length of the power line to prevent excessive voltage drops
(table 4).
Model
M400 SMART
11
Table 4
Cable (mm²)
Type of motor
1.5 2.5
230 V
0 - 22 23 - 26
11.7 A
GB
4.0
28 - 43