Rain i-dial Instrucciones página 28

Problem
Problem
The display shows
"No AC"
The rain sensor is
not pausing the
system when it
should be.
The Display is
blocked or shows
incorrect informa-
tion
The controller does
not stop watering.
Warning: Any unauthorized changes to this unit
that is not expressly approved by the manufactu-
rer for compliance could cancel the right to use
this equipment and will void the warranty.
28
Causes
There is no AC power coming
into the controller.
Rain sensor defective or not
connected correctly.
Stations have been program-
med to keep out the sensor
Peak voltage
Too many start times have
been programmed
Solution
Check that the fuse is intact.
Check that the transformer is
connected properly.
Verify that the rain sensor is
wired to the controller correctly
Re-program with the exclusion
of the sensor to activate it
Reset the controller and pro-
gram again
Program the controller again
NOTE: This device has been tested and com-
plaint declared with imposed limits on Class B,
Part 15 digital devices provided for the FCC Ru-
les.
These limits are designed to provide a reasonable
protection against harmful interferences in a resi-
dential location.
This equipment generates, uses, and can
emit radio frequency energy and, if not used
RAIN s.p.a.
via Kennedy 38/40
20023 Cerro Maggiore
ITALY (MI)