Installation Instructions - Acquaer PCP025 Manual Del Propietário

WARNING: Always use handle to lift pump. Never use power cord to lift pump. To avoid skin
burns, unplug and allow time for the pump to cool after periods of extended use.
Estimated Assembly Time (New installation): 5 minutes
1. Pump should always stand upright on base when operating. Do not suspend pump by means of
discharge hose or power cord. Keep pump inlet screen clear.
2. To install a garden hose, first install check valve adaptor provided with pump
2
3. Power Supply: Pump is designed for 115V, 60 HZ. Operation and requires an individual branch circuit of
15 amperes or more capacity. It is supplied with a 3-wire
cord set with grounding-type, GFCI protected plug for use in
a 3-wire, grounded outlet. For safety, pump should always
be electrically grounded to a suitable electrical ground such
as a grounded water pipe or a properly grounded metallic
raceway or ground wire system. Do not cut off the round
grounding prong.
WARNING: Risk of sudden starts. Can cause electrical shock and personal injury. The pump motor is
equipped with automatic resetting thermal protector and may restart unexpectedly. Protector tripping is
indication of motor overloading as a result of operating pump at high pressure, excessively high or low
voltage, inadequate wiring incorrect motor connections, or a defective motor or pump.
Automatic Operation
The pump will only turn on if there is approximately 2 in. of water around the pump. Water must
make contact with the sensor probes of the pump in order for it to turn on.
When the pump removes water down to approximately 2/5 in., the pump will run for an additional 10
seconds and then turn off.
Note: If the pump does not turn off, remove the pump and check to make sure that water or other
debris is not still contacting the sensor probes.
The pump can remain plugged in and will automatically turn back on when water reaches approximately
2 in. again.
PREPARATION

INSTALLATION INSTRUCTIONS