Care And Maintenance; Troubleshooting; Corrective Action; Warranty - Kobalt KRH 124B-03 Manual De Usuario

CARE AND MAINTENANCE

All maintenance should only be carried out by a qualified service technician.
Cleaning
Before cleaning or performing any maintenance, disconnect the plug from the power source.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your rotary hammer; never use detergent or alcohol.

TROUBLESHOOTING

WARNING
• Turn the switch to the "OFF" position, place the direction-of-rotation selector (D) in the
center-lock position before performing troubleshooting procedures.
PROBLEM
Tool does not work.
Bit doesn't rotate.
No hammering
action and the tool
wobbles.

WARRANTY

For 5 years from the date of purchase, the tool is warranted for the original purchaser to be
free from defects in material and workmanship. This guarantee does not cover damage due
to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use. This warranty is limited to 90 days for commercial and rental use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
Low battery capacity.
Operating mode selector
knob not engaged.
1. The tool is too cold.
2. Operating mode
selector is set to
drilling mode.

CORRECTIVE ACTION

Charge the battery pack.
Move the operating mode selector until it
engages.
1. Allow tool to reach the minimum
operating temperature.
2. Set operating mode selector to hammer
drilling mode or chiseling mode.
15