Hilti AG 125-A22 Manual Del Usuario página 27

Electrical safety
▶ Before beginning work, check the working area for concealed electric cables or gas and water pipes.
External metal parts of the power tool may give you an electric shock if you damage an electric cable
accidentally.
Using and handling power tools with care
▶ Do not use cutting discs for grinding.
▶ Tighten the accessory tool and flange securely. If the accessory tool and flange are not tightened
securely, the accessory tool may work loose from the spindle due to the braking effect of the motor after
switching off.
▶ Comply with the manufacturer's instructions for handling and storing grinding discs.
2.1.4 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product
2111866
*2111866*
Printed: 18.06.2018 | Doc-Nr: PUB / 5223753 / 000 / 03
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
Guard release button
Spindle lockbutton
Air vents
Release button with additional function
(charge status display activation)
Battery
Switch-on interlock release button
On/off switch
Vibration-absorbing side handle
Spindle
Standard guard
Clamping flange with O-ring
Abrasive cutting disc / abrasive grinding disc
Clamping nut
Kwik lock clamping nut (optional)
Wrench
English 21