Metra 99-6520B Instrucciones De Instalación página 5

ISO DIN radio provision with pocket
1. Mount the pocket to the radio
brackets with (2) #8 x 3/8" Phillips
screws supplied. Note – Pins on
brackets will align with front
mounting hole of pocket.
Figure A
2. Slide the aftermarket radio into the
radio bracket/pocket assembly and
secure with the screws supplied
with the radio. Figure B
3. Locate the factory wiring harness
and antenna plug in the dash.
Refer to the Axxess Interface
Wiring section of this manual.
4. Mount the new radio/pocket
assembly into the dash and
reassemble dash in reverse order
of disassembly using the
99-6520B radio trim panel.
Kit Assembly
(Figure A)
(Figure B)
99-6520B
Double DIN radio provision
1. Break the small locating pin from
the inside surface of each bracket.
Figure A
2. Mount the DDIN radio to the radio
brackets using the screws supplied
with the radio. Figure B
3. Locate the factory wiring harness
and antenna plug in the dash.
Refer to the Axxess Interface
Wiring section of this manual.
4. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly using
the 99-6520B radio trim panel.
5
Remove pin
(Figure A)
(Figure B)