Publicidad
en | 9 | T40092
2 General Safety Instructions
WARNING
Read and follow all safety notes and instructions!
Failure to follow the safety instructions may result in
serious injuries and material damages.
Observe and follow the safety notes below.
The load holding device has been specifically
constructed for its intended use. The safety of the
load holding device can no longer be ensured if it is
misused or modified in ways not expressly approved
by the manufacturer. Serious injuries or damage to
property can occur.
Ensure that each person using the load holding
device is familiar with these instructions and can
access them at all times.
Ensure that all users are also familiar with the
operating manuals of all tools and workshop
equipment, which are necessary for the work.
Carefully read and adhere to the instructions in the
technical safety information of the Volkswagen
Group brands.
Wear safety shoes (according to ISO 20345, S2).
Wear protective gloves in order to avoid cuts.
Position hands and feet carefully to avoid potential
crushing hazards.
Use the load holding device only for work approved
by the Volkswagen Group.
Use the load holding device only with the
accessories approved by the Volkswagen Group.
Do not exceed the maximum load capacity in
accordance with the "Load capacity of the tools"
table and observe the distance measurements in
Figure 2.
Only use the supplemental set for work in
accordance with the workshop manuals of the
Volkswagen Group brands.
Check all movable parts for function and ease of
operation.
Ensure that all required parts are securely
connected.
2018-06-25
Use screws of the prescribed quality and dimension
(see workshop manuals of the Volkswagen Group
brands).
Tighten the screw connections with the prescribed
torque (see workshop manuals of the Volkswagen
Group brands).
Only use the original locking pins and secure them
with the spring cotter.
Check the spring cotters for functionality.
Only use the traverse T40092/1 in connection with
the two counter bearings T40092/2 and T40092/3.
The supports T40091/2 are supported on the
traverse (Figure 2).
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany
Publicidad
Capítulos
