Krystal Pure KS5 Manual Del Propietário página 34

460i CONTROL TROUBLESHOOTING GUIDE FOR KS5 & KS10
PROBLEM
Clock does not display
correct time of day.
Time display continues to
advance.
Time display shows
something other than time
of day.
No water flow display when
water is flowing.
Control regenerates at
wrong time of day.
Timer stalled in
regeneration cycle.
Continuous regeneration.
Camshaft does not stop at
the end of regeneration.
Control will not regenerate
automatically or when
button is pressed.
Control will not
regenerate automatically
but will regenerate when
button is pressed.
33 • 02/17 KPWS
POSSIBLE CAUSE
Defective circuit board.
Outlet operated by switch.
Incorrect voltage or
frequency (Hz).
Power outages.
Defective time set switch.
Electrical interference.
Defective circuit board.
Bypass valve in bypass.
Meter probe disconnected
or not fully connected to
meter housing.
Restricted meter turbine
rotation due to foreign
matter in meter.
Defective meter probe.
Defective circuit board.
Power outages.
Clock set incorrectly.
Motor dead.
Motor runs backward.
No electric power at outlet.
Broken gear.
Defective switch.
Air leak in brine
connections.
Binding of camshaft.
Water pressure greater
than 125 PSI during
regeneration.
Defective circuit board.
Broken switch activator on
gear.
Defective switch.
Electric cord unplugged.
No electric power at outlet.
Defective motor.
Broken gear.
Binding in gear train.
Defective switch.
If water flow display is not
operative, refer to item 5.
Defective circuit board.
Incorrect hardness and
capacity settings.
continued
SOLUTION
Replace timer.
Use outlet not controlled by switch.
Replace timer with one of correct
voltage and frequency (Hz).
Reset clock.
Replace timer.
Disconnect power to unit. Restore
power and reset time of day.
Replace timer.
Shift bypass valve to not-in-bypass
position.
Fully insert probe into meter housing.
Remove meter housing, free up
turbine and flush with clean water. Do
not disassemble turbine from meter
housing. Turbine should spin freely. If
not, replace meter!
Replace timer.
Replace timer.
Reset clock to correct time of day.
Reset clock to correct time of day.
Replace timer.
Replace timer.
Repair outlet or use working outlet.
Replace timer.
Replace timer.
Check all junction points and make
appropriate corrections.
Remove foreign object obstruction from
valve discs or camshaft.
Install pressure regulator.
Replace timer.
Replace timer.
Replace timer.
Connect power.
Repair outlet or use working outlet.
Replace timer.
Replace timer.
Replace timer.
Replace timer.
Same as item 5.
Replace timer.
Set to correct values. See
Programming section.
...