Hkoenig JOE50 Manual De Utilización página 4

INSTRUCTIONS
1. Before power is supplied to the fan, ensure that the
voltage and frequency is the same as the nameplate.
2. Assembling the guard and the blades.
2.1. It is fixed the back guard on the motor by the mounting
screw.
2.2. It is loosened the cap nut. Fixes the blades on the rotor
shaft by locked the blade's screw. Finally locked the cap
nut into the rotor shaft.
2.3. It is fixed the front guard on the back guard by locking
the guard's screw.
3. The switch has for buttons numbered 0, 1, 2 and 3,
including off, slow,
medium and fast, respectively.
4. The oscillation switch controls the swing of the fan.
ATTENTIONS
1. Unplug the fan before maintenance. Do not touch the
fan if your hands are wet.
2. Do not connect to main power supply or switch on the
fan before assembly is completed.
3. Those who are not qualified electricians should not
disassemble, repair or rebuild the fan.
4. Unplug the fan when it is not being used.
5. Do not unplug the fan by holding the wire.
6. Do not use the fan if the wire or plug has been
damaged, or if the power socket is loose.
7. Do not repair the fan when the wire is damaged.
8. Do not use the fan near any of the following: gas stove
or any fire source, unusually humid or high temperatures,
oil soot with a lot of metal powder, or unstable places not
good for oscillation.
9. Do not insert your hand into the guard, or movable
parts.