Technical Data; Vibration Information; Noise Data - Worx WG546E Traducción De Las Instrucciones Originales

1. HANDLE
2. ON/OFF SWITCH
3. FAN HOUSING
4. TUBE RELEASE BUTTON
5. UPPER BLOWER TUBE
6. LOWER BLOWER TUBE
7. MOTOR HOUSING
8. BATTERY PACK*
9. BATTERY PACK RELEASE BUTTON*
*Not all the accessories illustrated or
described are included in standard delivery.

TECHNICAL DATA

Type WG546E WG546E.1 WG546E.2
WG546E.3 WG546E.9 (520-559-designation of
machinery, representative of Cordless Blower)
WG546E
WG546E.3 WG546E.1 WG546E.9
WG546E.2
Rated
voltage
Air speed
Air
volume
Charging 5hr 6.25hr
time (approx.) (approx.)
Machine
2.6 kg
weight
** Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.

NOISE DATA

A weighted sound pressure
Cordless Li-Ion Blower/Sweeper
20V Max**
I: 97km/h
II: 145km/h
I: 6.4m³/min
II: 9.6m³/min
2hr
/
(approx.)
2.9 kg 1.9kg
L : 83dB (A)
pA
K : 3.0dB(A)
pA
A weighted sound power
Wear ear protection

VIBRATION INFORMATION

Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
L :99dB(A)
wA
a < 2.5m/s
2
h
K = 1.5m/s²
5
EN