Environmental Instructions - Würth 0715 53 170 Traducción Del Manual De Instrucciones De Servicio Original

Measuring point light
Holding the "L.H" (data hold) button depressed for
a short time switches the measuring point light on
and off.
Continuity test
Place the test probes against the lead, fuse, etc. to
be tested. At a resistance of 0 - 2 kΩ, the resistance
value is output to the display and an audible signal
sounds to approximately 50 Ω. If the measured
value >2 kΩ, the overflow indicator "OL" is output
to the display.
FI/RCD trip test
The Multi-Tester Pro LCD has a load which allows
an FI/RCD circuit breaker to be tripped by means
of two buttons (FI\RCD). The FI/RCD (max. 30 mA)
is tested between phase and PE conductor (max.
240 V).
Backlighting
Backlighting is permanently activated.
Frequency measurement
During voltage measurement, the frequency of the
applied AC voltage is measured and output to the
display in small characters.
Battery changing
If the batteries have become discharged, a warning
signal is displayed and the device switches off.
Replace the batteries immediately in order to ensure
the accuracy of the measured values.
To change the batteries, open the battery compart-
ment on the main housing.
Loosen the screws using a suitable screwdriver. Pay
attention that the new batteries are inserted with the
correct polarity!
Close the battery compartment again and tighten
the screws.
12
Maintenance / care
Keep the device always dry and clean. The
■
device may be cleaned using a damp cloth.

Environmental Instructions

Do not throw the device away with
normal household waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally sound manner.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Any damage arising is remedied by the supply
of spare parts or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
We reserve the right to make technical changes.
We accept no liability for printing errors.