HoMedics SP-10HS-2EU Manual Del Usuario página 4

INSTRUCTIONS FOR USE:
Massage Function
NOTE: The first press of the power button turns the unit on; the second press turns on the heat
function with massage and the third press turns the unit off.
1. Plug the appliance into a 230V mains outlet.
2. To activate the massage action, press power button once (Figure 1).
3. To activate soothing heat with the massage, press the power button a second time.
Massage heads will glow red (Figure 2). Allow a few moments for the heating action
to warm up.
4. When finished press the power button again to turn off the massage and heat function and
unplug the pillow.
NOTE:
• The Shiatsu Cushion is designed for use on the neck, back and shoulders
(see Figures 3 and 4).
• Only gentle force should be exerted against the seat in order to eliminate risk of injury.
• There is a 20 minute auto shut-off on this appliance for your safety. This feature should not
be considered as a substitute for 'OFF'. Always remember to switch the appliance off when
not in use.
• Take care to position the product where it will not damage wooden or upholstered surfaces.
• For the neck and shoulders it may work better to use the pillow upside down
(as shown in Figure 5).
• The elasticated Velcro strap (situated on the rear of the cushion) can be used to secure the
cushion to the chair back (see figure 6).
CAUTION:
To avoid pinching do not lean on Shiatsu back massage mechanism in the cushion
when adjusting your body position.
Do not jam or force any part of your body in the moving massage mechanism.
(Figure 1)
(Figure 4)
(Figure 2)
(Figure 5)
5
(Figure 3)
(Figure 6)