Publicidad
Idiomas disponibles
Idiomas disponibles
17. Reconnect the data link connector and hood release
latch to the lower steering trim panel. Carefully snap
the panel back into place and secure with two (2)
fasteners at the bottom.
18. Reconnect battery.
RAM ITBM VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the added accessory in order to enable
system functionality. Using the DealerCONNECT website and the scan tool, complete the
procedure below:
1. Log on to https://dealerconnect.chrysler.com
2. In the service tab, inside the Warranty Administration box, locate “Vehicle Option Updates.”
Enter the vehicle VIN and add the sales code XHC (Trailer Brake Module) as a “Dealer
Installed Option”.
3. Confirm that the new sales code has been successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or wireless connection) and the vehicle,
follow the steps below:
4. Using the scan tool select the VEHICLE PREPARATION and then select RESTORE
VEHICLE CONFIGURATION.
5. Follow the step by step instructions on the scan tool to complete the Trailer Brake Module
configuration
6. When the Trailer Brake Module Configuration is complete, go to the Validation Process to
verify that the vehicle has been updated.
2/8/13
7
K6861628
Publicidad
