Installation; Positioning; Electrical Connection - Ariston DK F (IX) Manual De Instrucciones

Instructions for the installationist

Installation

These instructions are intended to be used by a qualified
installationist, who will be responsible for the installation,
adjustment and maintenance according to the laws and
regulations in force.
All operations must always be carried out with the
equipment disconnected from the electricity.
Positioning (Fig. 2)
The apparatus is designed to be set into a work surface,
as shown in the relevant illustration.
Fit the seal provided round the whole perimeter of the surface.

Electrical connection

Before connecting up the electricity, ensure that:
- the specification of the system is such as to match
that shown on the serial number plate applied to the
underneath of the work surface.
- the system is supplied with an efficient earth connection
to the ground, according to the regulations and the laws
in force. The earth connection is obligatory by law.
Apparatus class 1 Type X
In the case where the equipment is not supplied with
cable and/or relevant plug, make use of materials
suited to the input current shown on the serial number
plate, and to the working temperature. The cable must
not reach a temperature of more than 50°C higher than
the ambient temperature in any part of its length.
If connecting directly to the mains power supply,
fit a multi-pole switch of a suitable size for the rated
capacity with a clearance distance which completely
disconnects the power line under overvoltage category
III conditions, consistently with the rules of installation
(the yelIow/green earth wir must not be interrupted).
The plug or omnipolar switch must be easily reached
on the installed equipment.
N.B.: The manufacturer declines any responsibility in
the case where the above and the normal accident
prevention regulations have not been respected.
To avoid all risk, if the power cable becomes damaged,
it must only be replaced by the manufacturer,
by an authorised service centre, or by a qualified
electrician.
GB
Fig.2
5