Tabla de contenido
Publicidad
TOYOTA RS3200 P
Page 12
PROGRAMMING
The RS3200 P
is factory-set to not P
LUS
P
A
operation, as well as adjust the E
ASSIVE
RMING
more information on this feature, please refer to page 7. (Not applicable to Highlander and
Sienna. Please consult your Toyota Dealer for programming information.)
PASSIVE ARMING ON/OFF SELECTION, ENTRY DELAY TIME SELECTION
1.
Before you begin:
Open the driver's door. Close the remaining doors
and the trunk or hatch. Unlock all doors with the inside
lock switch. Remove the key from the ignition switch.
Start the Programming Procedure. (Complete these steps within 40 seconds.)
a. Close the driver's
door.
e. Open the driver's
door.
3.
Select the Operating Mode and Complete the Programming Procedure.
a. Close, then Open the driver's door:
2 times =
P
ASSIVE
3 times =
P
ASSIVE
0 Sec. E
4 times =
P
ASSIVE
15 Sec. E
5 times =
P
ASSIVE
30 Sec. E
Security system
LUS
ASSIVELY
b. Lock and unlock all
doors 3 times by key
or remote control.
f.
The system locks the door
in 2 seconds; if this does
not happen, start over.
b. Lock then unlock the
A
OFF
driver's door inside lock
RMING
A
ON,
button 1 time.
RMING
D
NTRY
ELAY
A
ON,
RMING
D
NTRY
ELAY
A
ON,
RMING
D
NTRY
ELAY
A
. To change the system's operation for
RM
D
time, follow the procedure below. For
NTRY
ELAY
2.
Insert and remove the key from
the ignition key cylinder 3
times; this must be completed
within 5 seconds.
c. Open and close
the driver's door.
g. Unlock the driver's
door knob.
c. The system locks the
door in 2 seconds; if this
does not happen, start
over. Programming is now
complete.
d. Lock, then unlock
the driver's door
inside lock button
3 times.
Publicidad
Tabla de contenido
