TMI VK61 Operación Manual página 2

Method 1
1) Set the crown to the normal position
2) Touch the AC terminal of circuit block and the switch spring with conductive
tweezers to reset the circuit.
3) The small second hand will move at two-second interval for 10 seconds as a
demonstration. (not applicable to VK64)
Method 2
1) Pull out the crown to the second click position.
2) Press the button B for two seconds and release the button.
3) Push the crown back to the normal position.
4) The small second hand will move at two-second interval for 10 seconds as a demonstration.
(not applicable to VK64)
* If the crown is operated within these 10 seconds, the two-second interval movement will not be activated.
(not applicable to VK64)
* It is not necessary to set the chronograph hands after the battery is exchanged. If the chronograph hand positions are
incorrect, following below procedure all the chronograph hands will be reset to "0" position
Button A
(START)
[ Standard measurement : e.g. 100m race ]
Press the buttons in the following order :
START
* Press button A to start the
chronograph. The
chronograph hands wil start
moving.
* The chronograph can measure up to
a measurement for
* To restart the chronograph function :
VK61 / VK63 / VK64 / VK67 :
VK83 : Press button B (to reset the chronograph minute hand to "0" position) then press button A
* During the chronograph operation, button B (reset) can be pushed. It will not cause any problem.
All manuals and user guides at all-guides.com
HOW TO RESET (AFTER BATTERY CHANGE)
Button A
(STOP)
HOW TO USE THE CHRONOGRAPH
STOP (Finish)
A
* Press button A again to stop
the chronograph. The
chronograph hands stop to
indicate the elapsed time.
VK61 / VK63 / VK64 : 60 minutes
VK67 : 12 hours
VK83 : 20 minutes
VK61 / VK63 / VK64 : 60 minutes
VK67 : 12 hours
VK83 : 20 minutes
Press button A
Button B
(Reset)
A A B
A
* Press button B to reset the
chronograph. All the
chronograph hands will be
reset to "0" position
and chronograph stops after
English
RESET
B