Tools Needed; Installing The Handle - Black Max BM80721SB Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

TOOLS NEEDED

See Figure 4.
The following tool (not included or drawn to scale) is needed
for assembly:
 Screwdriver
INSTALLING THE WHEELS
See Figure 5.
 Locate the axles, hitch pins, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.

INSTALLING THE HANDLE

See Figure 6.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Push and hold the push-pin button on the side of the handle
as you slide the handle onto the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slots to secure the handle in place.
ASSEMBLY
ATTACHING THE TRIGGER HANDLE STORAGE
BRACKET
See Figure 7.
 Place the trigger handle storage bracket over the hole in
the frame.
 Insert a screw through the hole and tighten securely.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 8.
 Push the end of the spray wand into the trigger handle
and rotate clockwise to secure.
 Place the assembled spray wand in the trigger handle
storage bracket.
 Pull on the spray wand to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE TRIGGER HANDLE
See Figure 9.
 Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 10.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
 Align the collar on the hose to the threaded outlet on the
pump.
 Install the high pressure hose collar onto the threaded
outlet.
 Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 9 — English

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido