Tripp-Lite BHDBT-K-E3SI-ER El Manual Del Propietario página 8

Installation
12. If you are using a remote control on the transmitter side of the installation to
control a device on the receiver side (such as a TV), connect the IR-OUT cable
(with green 3.5 mm connector) to the IR-OUT port on the remote receiver unit.
Note: The IR-OUT unit receives the signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g. Blu-ray player, TV).
13. Connect the three 10/100 Ethernet ports on the receiver unit to your devices
(e.g. monitor, etc.) and/or a LAN.*
14. Connect the external power supply to the remote receiver unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution
Unit (PDU). Models that support PoE will not require power at the receiver.*
15. Turn on the power to the HDMI source and RS-232 serial source.
* See the HDBaseT Features Chart on page 3 of this manual for the features your product supports.
18-11-132-933802.indb 8
8
11/15/2018 10:32:10 AM