Troubleshooting - Skil PS4563B-00 Manual Del Propietário

TROUBLESHOOTING

Problem
Motor does not run.
Motor runs, but
chain does not
rotate.
28
Cause
1. The battery pack is not
attached to the pole saw.
2. There is no electrical
contact between the saw
and battery pack.
3. The battery pack is
depleted.
4. The battery pack or pole
saw is too hot.
5. The lock-off button is
not depressed before
pressing the trigger
switch.
6. Saw chain is bound in the
wood.
7. Debris in bar groove.
8. Debris in side cover.
Chain does not engage drive
sprocket.
Remedy
1. Attach the battery pack to the pole
saw.
2. Remove the battery pack, check
contacts and reinstall the battery pack.
3. Charge the battery pack.
4. Allow the battery pack or pole saw to
cool.
5. Press down the lock-off button and
hold it, then depress the trigger switch
to turn on the pole saw.
6. Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the pole saw.
7. With the saw turned OFF, press the
saw chain against the wood, move the
pole saw back and forth to discharge
the debris.
8. Remove battery pack, then remove
side cover and clean out debris.
Reinstall the chain, making sure that the
drive links on the chain are fully seated
on the sprocket.