Use As A Hedge Trimmer; Assembling The Telescopic Arm; Adjust The Height Of The Telescopic Arm; Adjusting The Working Angle - Grizzly AGS 72-3 Lion-Set Traducción Del Manual De Instrucciones Original

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.
Assembling the telescopic
arm
Ensure that the safety key (
is removed before all tasks.
Putting the telescopic arm
together:
1. Put both parts of the telescopic
arm (18) together and tighten
the screw.
Make sure that the cable is not
clamped.
Assembling/dismantling the
telescopic arm:
2. Push the device along the guide
rail (
holder (24) of the telescopic
arm. It locks into place audibly.
3. To dismantle, pull the device out
of the holder (24) with moderate
force.
Adjust the height of the
telescopic arm
Adjust the length of the telescopic arm for
your size with the help of the adjusting
screw (19).
Adjusting the working
angle
For a comfortable edge cut, the equip-
ment holder (24) of the telescopic arm can
be rotated to the right or left.
11) into the equipment
Set the desired position by pulling the
release switch (22) and rotating the equip-
ment holder (24) of the telescopic arm.
The equipment holder locks into the de-
sired position when the release switch is
released.
Switching on and off
(with telescopic arm)
6) 1. Remove the blade guard (
before switching the device on.
2. Insert the safety key (
device.
3. To switch on, hold the switch lock (20)
on the handle of the telescopic arm
and simultaneously press the on/off
switch (21). Release the switch lock,
device runs at top speed.
4. To turn it off, release the on/off switch
(21).
Working with the telescopic
arm
• Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original parts.
There is a risk of injury!
Ensure that the safety key (
is removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
GB
14/17)
6) into the
6)
97