ECCOTEMP CEL10 Manual Del Usuario página 11

Phone: 866-356-1992 | Email: Support@eccotemp.com
Adjustment
The temperature of the outgoing water is dependent on the temperature of the
incoming water balanced with the amount of heat applied. Use extreme caution in
setting the outlet water temperature.
1. With the water regulator set to high, and the gas regulator set to
low, feel the outgoing water. This is the lowest setting available.
2. To initially raise the outgoing temperature, slowly turn the gas valve
towards maximum. Adjust slowly and check the temperature often.
There will be a slight delay between increasing the gas supply and the
increase in water temperature.
3. Should the outlet water temperature need to be higher, slowly reduce
the water flow regulator until desired temperature is reached.
(Warning: Do not alter or change this water heater's original
temperature sensor)
WARNING:
WATER HEATER IS CAPABLE OF PRODUCING
SCALDING WATER TEMPERATURES!
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS.
THIS MODEL IS PART OF OUR PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.
Support: Eccotemp.com/help-desk
THE PORTABLE TANKLESS
AFTER EVERY USE.
Shop Online: eu.eccotemp.com/products Store Locator: Eccotemp.com/locator
11