Overmax X-Blast Manual De Usuario página 16

NOTE After using in the car, wait 10-15 minutes before you start charging
the battery. Do not leave the charging battery unattended. Recommended
charger parameters: 5V
EN
4. How to assemble batteries in the controller
(see fig. 4):
1.
Remove battery cover.
2.
Insert 3 AA batteries 1.5V. Pay special attention to battery polarity.
3.
Put the cover back on.
A red flashing LED on the controller means the battery is low. Stop the car and
replace all three batteries 1.5V AA.
5. How to pair controller with the car (see fig. 5):
• Slide the on/off switch on the car into „ON". Switch the on/off switch
into „ON" to start the car.
• Slide the on/off switch on the controller into „ON". Power LED will go on.
• If the LED fails to go on, check the controller's batteries for suitable
condition and proper assembly.
• Wait for about 15 seconds until the controller connects to the car.
6. How to control the vehicle (see fig. 6):
• Turn the knob left or right to move front wheels.
• Press the controller's throttling valve to go forward. The farther you move
the valve, the faster the car drives. Move the throttling valve forward to
brake and then reverse.
7. Description of controller functions:
• If you can see the car deviates to the left or right instead of going straight,
you can adjust the turn with toe-in adjustment on the controller. Keep
the front of the car in the air when using the adjustment (see fig. 7).
1A.