Mhouse DS1 Instrucciones Y Advertencias Para La Instalación Y El Uso página 4

5 Usage
The DS1 digital selector emits a tone each time a button is pushed confirming that it has been performed correctly.
The DS1 cannot send a radio command until the command transmission has been enabled through the introduction
of the secret combination, after which the A B C buttons can be pushed to send the command as if the DS1 was a
normal radio transmitter.
The factory set combination of "11" can be changed at any time as described in the "Change of combination" chapter.
The secret combination is composed from a minimum of 1 number to a maximum of 10 numbers (for example: 5 or
5566778899).
If no buttons are pushed within 10 seconds the combination will have to be introduced once again in order to send
another command.
If the combination is incorrectly introduced, three rapid notes are emitted (beep-beep-beep) when the transmission
is attempted that indicate that the combination has been incorrectly typed in.
To make the introduction of the combination easier, the buttons can be lit up at any time by pushing button [Z] in
Fig. 1.
6 Change of combination
The secret combination can be changed at any time as long as the present combination is known.
To change the combination, proceed as described in table "B".
Table "B" Change of combination
1 Push button
Type in the present combination
2
3
Push button
4 Type in the new combination (max 10 numbers)
5 Push button
6 Type in the new combination again (max 10 numbers)
7 Push button
Three beeps are emitted if the operation has been successful otherwise 5
8
rapid beeps are given indicating that one of the steps was unsuccessful.
NOTE: If one wishes to use DS1 without having to introduce a combination, a combination with no numbers can be
introduced by not pushing the buttons at points 4 and 6 of table "B".
If the combination is forgotten it can be changed by repeating the above mentioned points and introducing the spe-
cial "PUK code" instead of the combination at point 2 of table "B".
Each DS1 has its own individual 10 digit "PUK" code which can be found on the front cover of this manual.
4
[Z] of fig. 1
[Z] of fig. 1
[Z] of fig. 1
[Z] of fig. 1
Example
1 1
1 2 3
1 2 3