Panasonic WV-Q169A Instrucciones De Operación página 9

Step 4
Attach the safety wire to the mounting chassis
as shown in the following drawing.
Safety wire
(Accessory)
Cables
Pass the loop
through the
tip of the
safety wire.
Step 5
Insert the anchor bolt (for securing the mount-
ing chassis) into the mounting hole of the
mounting chassis.
To adjust the position of the Panasonic logo on
the decorative cover, rotate the mounting chas-
sis. Note that the Panasonic logo will be
located at approximately 180 ° opposite side of
a hook for the decorative cover.
Mounting hole
Approx. 10 °
Roof space
Ceiling board
Mounting
chassis
Hooks (x3)
Direction of brand logo
Step 6
Secure the mounting chassis to the ceiling
board with the ceiling board fixing screws (4
positions).
Turning the ceiling board fixing screws clock-
wise provides ceiling board tightening between
the bottom of the mounting chassis and ceiling
board fixing bracket resulting in mounting chas-
sis securing.
(Recom mended tightening torque:
0.78 N·m {0.58 lbf·ft})
IMPORTANT:
• When securing this bracket on the ceiling,
make sure that the four ceiling board fixing
brackets are open as shown in the following
figure.
Anchor bolt
(for connecting the safety wire)
Anchor bolt
(for securing the mounting chassis)
Double nuts
(locally procured)
Ceiling board
fixing bracket
Ceiling board
Step 7
Use double nuts (locally procured) to secure
the mounting chassis after inserting the anchor
bolt (for securing the mounting chassis).
Ceiling board
fixing screw
Turn clockwise
9