Basic Operation - Tripp-Lite OMNIPRO 500 El Manual Del Propietario

Basic Operation

Switches
With your UPS plugged in, set this switch according to the
recommendations in Step 3 of the Quick Installation section.
OFF ON
"ON" Position
Function: ENABLES battery backup. UPS Conditions: The UPS
battery is charging. Power is ON at the UPS receptacles. The "
indicator light is illuminated. Setting Advantages: UPS provides
AC power from battery during power failures.
"OFF" Position
Function: DISABLES battery backup. UPS Conditions: The UPS
battery is charging. Power is ON at the UPS receptacles. The " "
indicator light is illuminated. The "
Setting Advantages: UPS does not provide AC power from battery
during power outages, conserving battery power when equipment
is not in use.
Use this momentary switch to do three things:
Silence the UPS On-Battery alarm
Move this switch to the left and release it to silence the UPS On-
Battery alarm, a series of short beeps followed by a brief pause
that is activated when the UPS is providing AC power from battery.
Note: When the battery is nearly depleted, the Low Battery
alarm—a continuous beep that cannot be silenced—will alert you
to immediately shut down connected equipment.
Test your UPS's battery charge
Leave your connected equipment ON. With your UPS connected
to AC power and turned ON, move this switch to the left, hold it
there for 2 seconds and release it. The UPS will emit several short
beeps as it momentarily switches to battery to test its charge. If
the UPS Low Battery alarm sounds (a long, continuous beep) or
the properly-sized load is not supported, let your UPS charge its
batteries for 12 hours and repeat the test. If alarm still sounds,
contact Tripp Lite for service. CAUTION: Do not unplug your UPS
to test its batteries. This will remove safe electrical grounding and
may introduce a damaging surge into your network connections.
Cold-Start your UPS
If your UPS is equipped with a MUTE/TEST switch, you may "cold
start" it and use it as a stand-alone power source when utility
power is not present, providing that the UPS's battery is charged.
To "cold start" your UPS, first turn the "OFF/ON" switch ON.
Then, move the MUTE/TEST switch to the left, hold momentarily
and release when the "
4
" indicator light is flashing.
" indicator light begins to flash.
"