Publicidad
Idiomas disponibles
Idiomas disponibles
154728-01 rev
9/10/02
2:23 PM
not operate tool when you are tired.
• CHECK DAMAGED PARTS. Before further use of the tool, a guard
or other part that is damaged should be carefully checked to
determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by authorized service
center. Do not use tool if switch does not turn it on and off.
Additional Safety Instructions for Rotary
Hammers
• WEAR SAFETY GOGGLES or other eye protection.
• WEAR EAR PROTECTORS when hammering for extended
periods.
• ALWAYS USE THE SIDE HANDLE supplied with the tool. Keep a
firm grip on the hammer when it is operating.
• DON'T OVERREACH. Maintain a firm, balanced working stance.
When necessary, use only properly positioned, safe platforms,
ladders and scaffolds, to do the job safely.
• Hammer bits and tools get hot in operation. Wear gloves when
touching them.
•
CAUTION: When drilling or driving into walls, floors or wherever
"live" electrical wires may be encountered, DO NOT TOUCH ANY
FRONT METAL PARTS OF THE TOOL! Hold the tool only by the
plastic handle to prevent shock if you drill or drive into a "live" wire.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
All manuals and user guides at all-guides.com
Page 2
2
FIG. 1
STEEL RING
PIN
BUSH
CLAMP NUT
CLAMP KNOB
FIG. 2
DEPTH ROD
SIDE HANDLE
SIDE HANDLE
Publicidad
